It would not allow me to enter anything else as a 'custom' size. I tried editing the part, but only had 4 options, 48", 60" 72", and 96". The visual plan view block I am using in the structure style is 12" diameter. The part I was using is 48" diameter, the smallest we have. The pipe will then have a 2D inside lenth based on 12" diameter structure parts. Once the smaller diameters are available you can add them to your parts list and swap those smaller 12" parts in place of the 48" parts. If so, you need to edit the structure part in partbuilder to add the smaller diameters to the part model. I hate doing that, it defeats the purpose of dynamic capability, and if there are changes moving forward I will have to remember to keep up, but it got it out the wrote:Īre you saying that you're using 48" diameter structure parts to represent structures that are actually 12" diameter? What I ended up doing, and this is only acceptable to me because it is a small network of less than a dozen structures, is I kept the structures fully dynamic, and manually edited the pipe labels for length and slope. But then I lost my dynamic reading of the surface for the rim, and would probably lose my label description at random, too. I swapped the part to a null structure, which since it had no "inside" gave me an accurate pipe reading when I attached it to the side wall of the structure block. The smallest part we have for a round structure is 48" ID (even our smallest rectangular structure is 36" ID), hence our labeling is insisting on cutting 2 feet off each end of pipe, hence a 50' center-to-center pipe is labeling and calculating slope at a 46' length when it should be a 49' length. The intakes are actually risers for overflow, and are small, 12" ID. Problem is: We are doing a small network of subdrains for bioswale and detention purposes. I'm sure I could figure that out, but I've already spent too much time on just this issue and I have projects to get out the door. I started to read how to add a part option and my eyes started to glaze over. I tried adding a part to the parts list, and it only allows pre-set options for structure size. Adjusting the pipe rules didn't make a difference for me. The default in the label style is already set to "2D Length - To Inside edges".
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |